In the process of daily use of the vehicle, you may encounter due to insufficient battery capacity or damage caused by the engine can't start, in this case, you can use other vehicles starting, the power supply in parallel on the specific practices are as follows:
　　1, with a jumper wire, both ends connect two battery positive electrode respectively;
　　2, another jumper wires connect power supply car battery cathode and lose traction battery anode or cathode by wire;
　　3, adjust good lead position, make its and nacelle movement part, such as engine belt, each other;
　　4, provide the power of the vehicle should be starting, starting again after 1 min kui electric vehicles. After starting the two car engine idling about 3 min, wire should still be in this period of time in the connection state;
　　5, removing the connection with wires in the order of sequence, on the other hand, can provide power supply vehicle engine stall at this time, but please do not will lose traction engine flameout.
　　When the battery jumper starting, attention should be paid to the following questions: should be confirmed two car battery rated voltage is the same, power supply capacity of the battery (A, h) should be greater than losing the capacity of the battery. If there is no suitable power supply vehicle, also can use single battery power supply; Don't lose battery is the cathode wires and vehicle disconnected; Turn off all electrical equipment deficient trolley car.